Assembly Table Build

Build was done in September 2020

In this video I tried to capture most of the steps I took to create my new Assembly Table for my shop. I lost a few videos and forgot to record a few steps, but I included after the fact photos of most of the build.

2 thoughts on “Assembly Table Build

  1. EDMON CABLE HAWKS February 5, 2021 / 8:01 pm

    Have you replaced your camera on your machine ours is out and they sent us a new one but did not send us instructions

    • Dav Glass February 5, 2021 / 8:03 pm

      I’ve replaced the camera on both my lasers. Which one do you have?

Leave a Reply to Dav GlassCancel reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.